Andman® Andritz Medium consistency centrifugal pumps for Paper and Pulp Industry

Andman® Andritz Medium consistency centrifugal pumps for Paper and Pulp Industry

Tobee® Medium consistency centrifugal pumps for Paper and Pulp Industry is one kind centrifugal single stage single suction paper pulp and chemicals sewage,paper pulp pump .it is widely used in such as paper making industry ,water treatment industry ,sugar-making industry,starch industry,soda reuse industry .it can transport less than 6% concentration sewage water or fine slurrys from paper -making industry ,sugar -making and starch industry etc.,and it can also transport the non-abrasion medium in other industries.

Specification:

Size (discharge): 1″ to16″ Pump
Capacity: 30~ 2300 m3/hr
Head: 3m ~ 58 m
Handing solids: 0 ~ 650mm
Concentration: 0%~ 6%
Material:Cast iron,SS304,SS316L,Duplex stainless steel etc

Detailed specification:

1. High efficiency, Energy saving: operation efficiency is 3-10% higher than ordinary pulp pump, energy saving to 15-30%
2. Good NPSH, Long service: actual using life is twice-third time than ordinary pulp pump.
3. High concentrations, Non-clogging: transfer pulp concentration max to 6%.
4. Reasonable structure, Easy maintenance: Pump head is front, rear casing structure, when maintenance there is no need to remove pipe line, only remove the electric motor backwards, then could disassemble and repair the pump.

Tobee® Medium consistency centrifugal pumps for Paper and Pulp Industry Structural Drawing:

Tobee® Medium consistency centrifugal pumps for Paper and Pulp Industry
1.Front pump cover2.handhole cover3.Impeller4. Pump casing5. Pump cover
6. Shaft cover7. Packing gland8. Slinger ring9. Front bearing cover10. Shaft
11. Breathable cover12. Oil flag13. Bearing frame14. Back bearing cover15. Support base
16. Coupling on pump end17. Coupling for motor end18.Base plate19. Electric motor20. Couplingguard

Tobee® Medium consistency centrifugal pumps for Paper and Pulp Industry Quality Control:

Stages of manufactureQuality cotrol activities
Raw material arrivalSampling, material chemical analysis
Casting and compositionMaterial material chemical analysis of pump parts
Casting quality inspection
Key component machiningDimension precision inspection
Impeller balancing
General assemblyProcedure operaion
Hydraulic static test
Performance test of pump unitCapacity and head
Vibration and noise
Bearing temperature
Final inspectionPackaging of pump unit
Documents
Spare parts and accessories

Leave a Reply

Your email address will not be published. Required fields are marked *